My final product.
Built inside an ABS plastic box with solid connectors and waterproof.
Strong 3M double side foam tape to avoid drilling to fix.
Black wire taps into chassis ground.
Red wire taps in the car's fusebox, taps in an ACC+ fuse with the provided fuse tapper device.
ESI WIRE HARNESS (3 wires with GM plug) runs directly from ESI-BOX to ECA sensor.
Embeeded 240 Mhz dual core processor with wifi© and bluetooth© capabilities (UPESY exclusivity).
... and the magic is done.
Below a 128px x 64px display.
GM ECA sensor.
Long pipe model.
Short pipe model.
Quick clip connectors.
90 degres quick clip connector.
Custom length hoses.
Below two hoses for the Mazdaspeed6 / 6MPS platform.
Take a look below.
I can build 3 kit types.
- Kit assembled and tested with male steel connectors.
- Bluetooth data transmission (encrypted) to the included Android ESI application.
- Embedded web server accessible via Wifi acccess point or Wifi client.
- Wrapped harness with clamped connector for Ethanol Content Analyser sensor.
- Wrapped harness with clamped Fuse Tap unit for Car ACC+ and chassis ground round terminal.
- Kit assembled and tested with male steel connectors.
- Bluetooth data transmission (encrypted) to the included Android ESI application.
- Embedded web server accessible via Wifi acccess point or Wifi client.
- Wrapped harness with clamped connector for Ethanol Content Analyser sensor.
- Wrapped harness with clamped Fuse Tap unit for Car ACC+ and chassis ground round terminal.
- QLED display matrix 128 x 64 Px colors Yellow / Blue with clamped connector and cable.
- 3.0m QLED cable extender to connect the QLED display to the ESI-BOX.
- Kit assembled and tested with male steel connectors.
- Bluetooth data transmission (encrypted) to the included Android ESI application.
- Embedded web server accessible via Wifi acccess point or Wifi client.
- Wrapped harness with clamped connector for Ethanol Content Analyser sensor.
- Wrapped harness with clamped Fuse Tap unit for Car ACC+ and chassis ground round terminal.
- QLED display matrix 128 x 64 Px colors Yellow / Blue with clamped connector and cable.
- 3.0m QLED cable extender to connect the QLED display to the ESI-BOX.
- GM Continental Ethanol Content Analyser.
- Hoses kit with clamped quick-clip connectors to replace the factory hose.
Why I created Ethanol Sensor Interface ?
I was wondering about use ethanol to raise the power of my car's engine and get the lowest cost possible at fuel pump.
My mapper provides me a map capable of handling ethanol / unleaded gasoline mix respecting my engine limits.
That's why I created Ethanol Sensor Interface, because is up to me to keep the exact Ethanol / unleaded fuel mix. With this kit, I can take control of the current in-tank mixture.
- I can avoid serious engine damage due to incorrect mixture
- Very Easy to install and setup
- Monitor my mix in real time
- Check my current mix afer filling-up my car's tank